Fast Response Flexible Wire Air Probe (1m Lead)

Part No: AT22L (3058624)

The AT22L Fast Response Flexible Wire Air Probe is fitted with a steel braided lead and Type T Thermocouple Sensor.

  • Temperature Range: -40°F to +482°F / -40°C to +250°C
  • Sensor Type: Type T Thermocouple
  • Connector Type: 6-Pin Lumberg
  • Warranty: 6 Months

 

Fast Response Flexible Wire Air Probe

The AT22L Fast Response Flexible Wire Air Probe is fitted with a steel braided lead and Type T Thermocouple Sensor.

 

AT22L

 

The AT22L Fast Response Flexible Wire Air Probe is fitted with a 6-Pin Lumberg connector with locking screw, to provide a strong and secure probe-to-instrument connection with better prevention of liquid ingress.

Not suitable for intrinsically safe applications

Technical Specifications

NameValue
Sensor TypeType T Thermocouple
Connector Type6-Pin Lumberg
Temperature Measurement Range-40°C to +250°C / -40°F to +482°F
Response Time2.0 seconds
Lead Length1.0m (Approx 3ft)
Lead MaterialPTFE
Compliance Thermocouple: Tolerances relate to BS EN60584-2 (1993) Class 1
Warranty6 Months

*You will need to Sign In to view additional content

Documentation

 CodeDescriptionIssue NoLast Modified
20534US Product Range Catalog0224th April 2017

Articles / FAQs

NameDate
My Probe is stuck in the Lumberg connector?

My Probe is stuck in the Lumberg connector?

If you are using a Probe, connected to your device via a 6-Pin Lumberg connector and the Probe appears to be stuck in the connector, then it may have been over-tightened.

You should initially try to release the screw thread connector gently.

To prevent the connector from locking in the future, you could use food safe grease on the connector threads. This problem may also be prevented by keeping the instrument clean when in use.

If this does not work, you will need to return your instrument for service.

 

20th April 2015
General Care of Temperature Probes

General Care of Temperature Probes

The Probe is where most of the action with any Thermometer takes place. Almost every operation requires a Probe reading.  The Probe should be treated with care in order to ensure best functioning and long life.

We would recommend that you always have a spare, properly functioning Probe on hand, just in case the primary Probe breaks, or appears to be reading incorrectly.

You should not stretch the coiled cable of any Probe, to reach an item to be measured. We would recommend instead that you ALWAYS move BOTH the Probe and the Thermometer, toward the food to be measured. This will help avoid unnecessary stress on the wires inside the Probe.

You should not touch the coiled cable or Probe handle to hot surfaces, that might melt the protective coatings, which in turn could damage the Probe wires and render the Probe inoperable.

You should not bend the tip of any Penetration Probe, as this too could break the wires and render the Probe inoperable. In general, Penetration Probes are designed for penetrating thawed food only and not for testing frozen food or containers or chipping ice.

Probe

You should clean the Probe and wire coil with a clean damp cloth, being VERY careful not to pull or stretch the coil and damage the wires inside.